Malvern Instruments products apply advanced technologies such as laser diffraction, Zeta potential measurement, Non-Invasive Back-Scatter optics, and Image analysis
Mastersizer range

You are here:HomeLaboratory productsConsumablesWhy replace sample tubing?

Why does sample tubing need to be replaced?

The tubing connecting sample dispersion units and flow cells should have sufficient elasticity to maintain an air-tight seal. When tubing loses its elasticity, air will leak into the system at the points where the tubing is attached to the sample unit and the cell and the resulting bubbles in the system can give rise to instability in the backgrounds and in the sample measurements.

Pay particular attention to the condition of tubing if organic dispersants are regularly used since many of these, particularly toluene, will cause tubing to harden so that the act of moving a sample dispersion unit relative to the sizer can cause the tubing to become detached.

Buy replacement tubing online:
 
Replacement sample tubing for the Mastersizer
  
Sample tubing (AWA4018)
Tubing from sample unit to flow cell. 50 Feet in length. (4.76 mm Bore X 1.6 mm Wall)
 
Buy Mastersizer 2000 consumables